Posted by: acharnley
Re: Hilfe einen Verteiler für Igaro D1 in Deutschl - 08/26/16 12:30 PM
The pdf I used earlier explains the resistor type and time, 5ohm 10W ceramic. Not kept on long enough for heat to be an issue.
A wattmeter/voltmeter+ampmeter can only measure within good accuracy a pure sin wave - at least, I don't have a model that can sample wave energy and average it. The signal was read using a digital oscilloscope to ensure the amp wasn't overloading and distorting the signal. The amp I use to boost the signal generator is a class A/B 100W. I also use a class D 100W and get the same figures.
I hope your man isn't using the built in li-ions to skew the output results as the German translation is not clear. This would be very unfair.
A wattmeter/voltmeter+ampmeter can only measure within good accuracy a pure sin wave - at least, I don't have a model that can sample wave energy and average it. The signal was read using a digital oscilloscope to ensure the amp wasn't overloading and distorting the signal. The amp I use to boost the signal generator is a class A/B 100W. I also use a class D 100W and get the same figures.
I hope your man isn't using the built in li-ions to skew the output results as the German translation is not clear. This would be very unfair.